1.the number of particle disk height should be the same as the length of the head capsule capsule or slightly higher than the number of grains set, not too low or too high, otherwise it will spoil the capsule in the rotation, too low can pad for scraping the middle part of the middle and high hole matched with a shaft made after the abandoned VCDs, too please lathe a number of particles under the disc washer (do not get too low).
2.ring grain number on the disc must be adjusted to the appropriate height, bottom should keep a distance of about 1.5-2MM and the capsule head is too low will break the capsule.
3.the number of particle hole capsule not all fall not press the micro switch is full, otherwise it will damage to the location of the capsule in the ring. A number of holes in the capsule can not be fully filled with a brush to brush the capsules, so that a number of capsules have a capsule.
4.after wetting the deformation of the capsule can not be placed in the machine count.
5.the number of tablets can not be weighed, otherwise not normal work; lift the machine can not be carried on a number of tablets, otherwise it will cause the number of disc loose damage.
6.capsules must be locked completely, the length of unity, not qualified capsules.
Be careful:
1, lifting the machine must not be carried in the number of disc hopper
Otherwise, it will cause damage to the machine!
2, on foot: machine can be fitted with 4 screws and tighten the screw
As a mother machine feet.
